Textile Parts - Shark EvoLine series3 Manual De Instrucciones

rEmoVInG ThE InTErIor ParTs
We advise you to carry out this operation
ng
with the helmet in the Jet configuration.
asy
- Turn your helmet over;
ce
- Separate the two parts of the chin strap;
- Remove the neck pad by holding one of its
are
sides; pull out the end and then detach its
to
rear section (Fig. A);
pi- - Unclip the two cheek pads (Fig. B) and slide
them along the chin straps to extract them;
ear
- Unclip the rear part of the head sec-
tion in order to remove it from its housing
he
(Fig. C -D);
ia.
- To complete the operation, unclip the front
of the head section, starting with one side
gh
(Fig. E) and remove the head section.
for
nce
all
is
ear
ear
on
ce,
a
he
our
warnInG! The interior padding is
of
critical to maintain the correct fit of
en-
the helmet on your head. If you have any
met
doubt whatsoever regarding the removal
ust
or replacement of the interior padding,
Do noT usE Your hELmET. Contact your
ad-
retailer for assistance or advice. nEVEr
use your helmet with any part of the
interior padding removed. The helmet
on
will not protect you in an accident.
is-
warnInG! The polystyrene lining
4.
and interior padding are critical to
erManualEvoCarbon.indd 23
TExTILEs ParTs
properly fit your helmet on your head. an
improper fit could cause your helmet to
become dislodged in an accident, leaving
your head unprotected and resulting in
severe head injury or death. If you are
not sure that you properly replaced the
comfort padding, Do noT usE Your
hELmET. Contact your retailer for assis-
tance or advise.
B
C
E
23
D
24/07/14 16