Slings - Vermeiren Albatros Manual De Instrucciones

2.3.5 Raising and lowering the cantilever arm
The manual control allow the cantilever arm to be adjusted
smoothly to any point.
1
2
1 2
L
Force required to activate the pushbutton: < 5N
Position the manual control to the top tube of the handles for moving the patient hoist. This is
the most ergonomic position.
2.3.6 Moving the patient hoist
L
WARNING: Risk of clamping – Be careful passing through restricted passages
(e.g. doors).
Stand behind the patient hoist and grasp the handles (left and right, next to the battery
1.
and control box) with both hands.
Make sure that both back caster brakes have been released.
2.
Push the patient hoist slowly into the desired position.
3.
When it is not loaded, we advise you to pull the patient hoist backwards, which makes it
easier to get round any obstacles (door frames, corners of rooms or furniture).
To move the patient hoist use only the handles for pushing and no other components
(actuator, manual control, ...) .
2.4

Slings

L
WARNING: Risk of injury – Only use appropriate slings for the patients.
L
WARNING: Risk of injury – Do not use damaged slings.
The Albatros patient hoist must only be used with slings designed for the Vermeiren Albatros
patient hoists.
The applicability and instructions for use for the specific slings should be followed.
= Raise the cantilever arm
= Lower the cantilever arm
When using the lift function until the end of the hoist
motor the limit switch is activated by electronics (security
function). Use the lifting function only in the middle of the
adjustment range.
Page 11
EN
Albatros
2010-12