Control Panel - Panasonic EY4541 Manual De Instrucciones

Cutting at the same width
1. Place the base onto the workpiece
so that the edge of the rip fence
and workpiece are put together.
2. Without letting the blade touch the
workpiece, turn on the power switch.
3. Face the rip fence firmly to the
workpiece to cut parallel line.
Cutting circles
1. If cutting away a section, make a
drill hole on workpiece to let the
jigsaw blade pass through.
2. Align the pin hole of the rip fence
with the center of the circle, and
then use a nail or screw to hold the
object in place.
3. Without touching the workpiece,
turn on the power switch.
4. Cut along the marked line.

Control Panel

(1)
(1) LED light
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation ex-
posure.
- 12 -
(2)
Before the use of LED
light, always pull the
power switch once.
Press the LED
light button.
The light illuminates
with very low current,
and it does not ad-
versely affect
performance of the
driver during use or
its battery capacity.
(3)
the