Connect Ductwork - Best KEX30 Manual De Instrucciones

CONNECT DUCTWORK

1. Adjust the width of the flue mounting
bracket to equal the inside width of
decorative flue. Insert and tighten mounting
screws to hold bracket width. Use mounting
screws (4,8x38mm) and wall anchors to
secure flue mounting bracket to the ceiling
as shown.
2. Use 8" round metal duct to connect the
discharge collar on the hood to the
ductwork above.
3. Use duct tape to make all joints secure
and air tight.
4. Carefully place the lower decorative flue
into the recessed area of the range hood
top.
5. Extend the upper flue to the ceiling and
secure with two mounting screws
(3,9x9,5mm).
6. Secure lower flue to hood with the two
mounting screws provided (3,9x9,5mm).
BRACKET WITH MOUNTING
FASTEN FLUE TO
HOOD WITH MOUNTING
SCREWS(3,9x9,5mm)
FASTEN FLUE TO
SCREWS (3,9x9,5mm)
- 10 -
FLUE MOUNTING
BRACKET
MOUNTING
=
=
DECORATIVE
METAL DUCT
SCREWS
MOUNTING
SCREWS
(4,8x38mm)
FLUE
DUCT TAPE
8" ROUND