For Safe Use; Battery Recycling - Panasonic EY3640 Manual De Instrucciones

For hard compounds
EN
• When using a hard sealing compound, the
protection function for the battery pack and
motor may stop the operation of the tool. If
this occurs, adjust the speed dial and pull
the trigger again to continue the operation.
• Warm the sealing compounds until the com-
pounds become soft.
• Slow down the speed by selecting the appli-
cation speed control.
• Make the nozzle cut diameter bigger.
[Fig.13]
CAUTION:
• Make sure the front cap is tightened secure-
ly when working.
• Do not touch the rack to avoid getting your
fi ngers pinched.
• Use the tool only for its intended purpose,
and do not operate it for long periods of time
without interruption, since this may damage
the sealing gun or cause the cartridge to
jam. Do not insert a cartridge if it is wet, or if
the sealing compound has hardened.
• If the tool is operated for long periods of
time, the motor may overheat.
It is therefore recommended to switch it off
from time to time.
• The use of fl ammable materials, even for
cleaning purposes, is not permitted.
• The ambient temperature range is between
0 °C (32 °F) and 40 °C (104 °F). If the bat-
tery pack is used when the battery tempera-
ture is below 0 °C (32 °F), the tool may fail
to function properly.
• When charging a cool battery pack (below
0 °C (32 °F)) in a warm place, leave the
battery pack at the place and wait for more
than one hour to warm up the battery to the
level of the ambient temperature.
• If the tool is used in cold-temperature condi-
tions (such as during winter) or if it is fre-
quently stopped during use, the overheating
protection feature may not activate.
[Battery Pack]
For Appropriate Use of
Battery Pack
[Fig.14]
• The rechargeable batteries have a limited
life.
• For optimum battery life, store the Li-ion bat-
tery pack following use without charging it.
• When operating the battery pack, make sure
the work place is well ventilated.

For safe use

• The battery pack is designed to be installed
by proceeding two steps for safety. Make
sure the battery pack is installed properly to
the main unit before use.
• If the battery pack is not connected fi rmly
when the switch is switched on, the over-
heat warning lamp and the battery low
warning lamp will fl ash to indicate that safe
operation is not possible, and the main unit
will not rotate normally.
Connect the battery pack into the unit of the
tool until the red or yellow label disappears.

Battery Recycling

ATTENTION:
A Li-ion battery that is recyclable pow-
ers the product you have purchased.
Please call 1-800-8-BATTERY for infor-
mation on how to recycle this battery.
[Battery Charger]
Charging
CAUTION:
1) If the temperature of the battery pack
falls approximately below −10 °C (14 °F),
charging will automatically stop to prevent
degradation of the battery.
- 12 -