Saw Blade Mounting And Dismounting; Maintenance And Inspection - Hitachi Koki C 10FCB Manual De Instrucciones E Instrucciones De Seguridad

Sierra compuesta
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
To prevent an accident or personal injury, always turn off the trigger switch and disconnect
the power plug from the receptacle before removing or installing a saw blade.
1. Mounting the saw blade (Fig. 28-a and Fig. 28-b)
(1) Press in lock lever and loosen bolt with 10mm box wrench.
Since the bolt is left-hand threaded, loosen by turning it to the right as shown in Fig. 28-b.
NOTE:
If the lock lever cannot be easily pressed in to lock the spindle, turn the bolt with 10 mm box
wrench while applying pressure on the lock lever.
The saw blade spindle is locked when the lock lever is pressed inward.
(2) Remove the bolt and washer (C)
10 mm Box
Wrench
(3) Lift the safety cover and mount the saw blade.
WARNING:
When mounting the saw blade, confirm that the rotation indicator mark on the saw
blade and the rotation direction of the gear case (see Fig. 1) are properly matched.
(4) Thoroughly clean washer (C) and the bolt, and install them onto the saw blade spindle.
(5) Press in the lock lever and tighten the bolt by turning it to the left by 10mm box wrench as indicated
in Fig. 28-b.
CAUTION:
* Confirm that the spindle lock has returned to the retract position after installing or
removing the saw blade.
* Tighten the bolt so it does not come loose during operation.
Confirm the bolt has been properly tightened before the power tool is started.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.
CAUTION:
Never attempt to install saw blades larger than 10" (255 mm) in diameter.
Always install saw blades that are 10" (255 mm) in diameter.

MAINTENANCE AND INSPECTION

WARNING:
To avoid an accident or personal injury, always confirm that the trigger switch is turned
OFF and the power plug has been disconnected from the receptacle before performing
any maintenance or inspection of this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the first sign of deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade can cause ineffective operation
and possible overload to the motor.
CAUTION:
Never use a dull saw blade. When a saw blade is dull, its resistance to the hand
pressure applied by the tool handle tends to increase, making it unsafe to operate
the power tool.
Lock Lever
Fig. 28-a
Tighten
Bolt
Washer (c)
Loosen
Fig. 28-b
English
19

Publicidad

Tabla de contenido
loading

Tabla de contenido