Cutting Depth Adjustment; Collecting Dust - Panasonic EY4542 Manual De Instrucciones

Cutting depth adjustment

• Remove battery pack.
• Loosen the depth adjustment nut and adjust
the cutting depth, using the graduations on the
lower guard to gauge the depth. Once finished
adjusting the depth, tighten the depth adjust-
ment nut securely.
* When wood material is 10 mm (3/8") or less
thick, adjust the cutting depth so that the blade
protrudes approx.  mm (3/1") from the bottom
of the material.
Loosen
Depth
Tighten
adjustment
nut
Rip fence (EY3500B7727)
(Available as an accessory, not included)
Rip fence is convenient for rip cuts and repeated
cuts of uniform width.
• Remove battery pack.
• Insert rip fence and adjust cutting width. (See
Fig. 10)
• Fasten screw securely to fix rip fence.
Insert and
adjust
Rip fence
Fig. 10
Pull down
Fig. 9
Fasten screw

Collecting Dust

WARNING
* Before cutting metal materials, always empty
the dust case, open the front cover and
remove the dust.
• Use the tool with the flammable materials
in the dust case to cut metal materials may
result in fire
* When cutting metal materials, always use the
tool with the dust case attached.
• Flying sparks and metal chips may cause
injury.
* Do not carry or store the battery pack in
the same container as nails or similar metal
objects.
(1) Collect dust in the dust case.
* Empty the dust case when it is filled up with
dust.
* Empty the dust case before storing the tool.
* Dust case capacity
• When cutting electrical conduit with a
diameter of  mm (1"), approximately
130 cuts
• When cutting 4 mm (1-/3") x 4 mm
(1-/3") lumber, approximately 10 cuts
NOTE:
Some materials may cause dust to become
clogged inside the front cover when cutting
those materials.
() Use with vacuum cleaner to collect dust.
* Connect the tool to the hose using the
EY9X01E vacuum cleaner hose adapter
(sold separately).
Compatible hose inner diameter:  mm
(1") to 38 mm (1-/1")
* Operate the vacuum cleaner obeying its
instructions.
- 13 -
Front cover
Fig. 11