High Load Function; To Stop The Product; To Get A Good Result; To Cut Grass Without A Grass Catcher Or Mulch Plug Attached - Husqvarna LE121P Manual Del Usuario

1. Press the SavE button (A) to start the function. The
green LED comes on.
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically when the ground
conditions lets it.

High load function

When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.

To stop the product

The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out.
A
B
428 - 002 -
A
B
3. Open the battery lid and turn the safety key to 0.
4. To remove the battery, press the two release buttons
and pull out the battery.
5. Charge the battery if it is weak. For more
information, see To charge the battery on page 13 .

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.
15