Setting The Pin Code; Pairing This Unit And Bluetooth Wireless Technology Device - Pioneer XW-NAC1-K Manual De Instrucciones

Bluetooth ® AUDIO for Wireless Enjoyment of Music

Setting the PIN code

Set this unit's PIN code to the same setting as
that for the wireless technology
Bluetooth
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
STANDBY/ON
a
a
SLEEP
INPUT
SELECTOR
1 Press BT A.
When the wireless technology device
Bluetooth
is not connected, the BT AUDIO indicator
flashes. If the
Bluetooth
device is connected, disconnect it.
2 When the BT AUDIO indicator flashes,
press and hold VOLUME – on the top panel,
and then press and hold  STANDBY/ON for
three seconds.
The SHUFFLE indicator will flash, and the PIN
2
code will be changed. The number of flashes
corresponds to the newly set PIN code as
follows:
• 1 flash: 0000
• 2 flashes: 1234
• 3 flashes: 8888
Repeat step 2 until the PIN code is reset to the
value desired.
These settings are preserved in memory even
when the power is turned OFF. When resetting
the PIN code, turn the power ON, and perform
step 2 without any unit connected.
Note
1 • Pairing is required when you first use Bluetooth wireless technology device and this unit.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
b
VOLUME
wireless technology
Pairing this unit and Bluetooth
wireless technology device
"Pairing" must be done before you start
playback of wireless technology
Bluetooth
content using
Bluetooth
perform pairing first time you operate the
system or any time pairing data is cleared.
"Pairing" is the step necessary to register
wireless technology device to enable
Bluetooth
communications.
Bluetooth
see also the operating instructions of your
wireless technology device.
Bluetooth
1 Press BT A.
When the wireless technology device
Bluetooth
is not connected, the BT AUDIO indicator
flashes. If the
Bluetooth
device is connected, disconnect it.
2 When the BT AUDIO indicator flashes,
press .
The BT AUDIO indicator will flash fast, and the
unit will enter the pairing standby mode.
Bluetooth
3 Switch on the
technology device that you want to perform
pairing with, place the device within 1 meter
of the system, and set it to the pairing mode.
Pairing begins.
4 Check to see that the
Bluetooth
detected by the
technology device.
The BT AUDIO indicator lights when
wireless technology device is connected.
AUDIO. Make sure to
1
For more details,
wireless technology
wireless
Bluetooth
AUDIO is
wireless
Bluetooth
04
15
En