To Remove The Right Fender; To Remove The Covers; To Remove The Engine Cover; To Examine The Steering Wires - Husqvarna Rider 322T AWD Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Make sure that the intake grille on the engine cover
is not blocked. Remove grass and dirt with a brush.
Open the engine cover. Make sure that the engine
cold air intake is not blocked. Remove grass and dirt
with a brush.
Examine the air duct, found on the inner surface of
the engine cover. Make sure that the air duct is clean
and does not rub against the cold air intake.

To remove the covers

To remove the engine cover

1. Fold the seat forward.
2. Release the clip on the engine cover with the tool
attached to the ignition key.
3. Fold the engine cover rearward.
To remove the front cover
1. Release the clip on the front cover with the tool
attached to the ignition key.
2. Lift off the front cover.
20

To remove the right fender

1. Turn the knob on the reverse pedal (A) to remove it.
2. Remove the 3 screws (B) and lift off the right fender.
B
To remove the left fender
Remove the 3 screws and lift off the left fender.

To examine the steering wires

The tension of the steering wires can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.

To do a check of the parking brake

1. Park the product on a hard surface that slopes.
Note: Do not park the product on a grass slope when
you do a check of the parking brake.
2. Press the parking brake pedal down (1).
B
A
B
270 - 001 - 28.11.2017

Publicidad

Tabla de contenido
loading

Tabla de contenido