To Remove The Right Footrest Plate; To Replace A Broken Lamp; To Remove The Left Footrest Plate; To Examine The Steering Wires - Husqvarna R 418Ts AWD Manual De Usuario

2. Remove the front cover. It is attached to the
equipment frame with 2 hooks.

To remove the right footrest plate

1. Turn and remove the knob on the rearward drive
pedal (A).
2. Remove the 2 screws (B and C) and remove the
footrest plate.

To remove the left footrest plate

• Remove the 2 screws and remove the footrest plate.

To examine the steering wires

The tension of the steering wires can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
522 - 002 -
C
B
A
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.

To replace a broken lamp

1. Remove the 2 screws on the cover of the servo
housing and remove the cover.
2. Lift the cover and turn it around the steering shaft.
3. Remove the 2 screws that hold the lamp housing
and lift it out.
4. Disconnect the cables from the broken lamp and lift
it out of the lamp housing.
21