To Remove And Attach The Rear Right Cover - Husqvarna R112C Manual De Usuario

To replace the air filter, R112C5,
R115C
1. Open the engine cover.
2. Loosen the knobs that hold the air filter cover and
remove the cover.
3. Remove the air filter cartridge from the filter housing.
4. Put a new air filter cartridge on the air hose.
5. Push the air filter cartridge into correct position.
6. Attach the air filter cover and tighten the knobs.
1466 - 002 - 28.09.2020
To remove and attach the rear right
cover
1. Open the engine cover.
2. Remove the screw (A).
3. Turn the drive system lever (B) counterclockwise to
loosen it from the drive system.
Note: Do not remove the drive system lever
completely.
4. Remove the rear right cover. The drive system lever
is removed together with the rear right cover.
B
A
Note: The plastic covers are flexible. Bend them
carefully to make the removal easier.
5. Before you attach the rear right cover, make sure
that the drive system lever is in the correct position.
6. Put the rear right cover back in its initial position.
7. Put the hook at the end of the drive system lever
through the hole as shown (A).
21