Basic Settings; Setting The Clock - Pando PHV9400 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN

Basic settings

Setting the clock

After your microwave oven is first plugged in or
after a power failure, the clock display will flash to
indicate that the time shown is not correct. To set
the clock, proceed as follows:
1. Press
the
Clock
Clock/Duration display is showing the clock.
The hour numbers will start to flash.
2. Press the "+" and "-" keys to set the correct
hour value.
Water Hardness setting
The
appliance
features
automatically indicates when it is time to descale.
The system can be optimized for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range
of water hardness (see table below).
6
key
(5)
when
the
a
system
that
3. Press again the Clock key (5) to set the
minutes. The minute numbers will start to
flash.
4. Press the "+" and "-" keys to set the correct
minute value.
5. To finish, press the Clock key (5) again.
To set the water hardness parameter, proceed as
follows:
Press the "+" and "-" keys
1.
Hardness. Select the desired water hardness
according to the below table. The selected
parameter will start to flash on the display
(steps 1 is not necessary if the appliance is
first plugged in or after a power failure).
2. Press the "OK" key (4) to set the parameter.
The oven returns to the "ON" state.
to set the Water

Publicidad

Tabla de contenido
loading

Tabla de contenido