Milwaukee 0100-20 Manual Del Operador página 10

Installing and Removing Bits
WARNING!
To reduce the risk of injury, al-
ways remove the chuck key from
the chuck after each use.
Keyed Chuck (Fig. 3)
These tools are equipped with a chuck tight-
ened using a key. Always unplug the tool
before installing or removing bits.
1. To open the chuck jaws, place the
chuck key in one (1) of the three (3)
holes located on the chuck. Turn the
key counterclockwise (Fig. 3).
Fig. 3
Loosen
Be sure the bit shank and chuck jaws
are clean. Dirt particles may prevent
the bit from lining up properly.
2. When using drill bits, insert the bit into
the chuck. Center the bit in the chuck
jaws and lift it about 1/16" off of the
bottom. Tighten the chuck jaws by hand
to align the bit.
CHUCK IDENTIFICATION
Chuck Type
Keyed
Double sleeve
Keyless
Single sleeve
Keyless
3.
4.
Tighten
These tools are equipped with a hand tight-
ening keyless chuck. Always unplug the
tool before installing or removing bits.
1.
10
Drill Cat. No.
0100-20
0101-20
0200-20
0299-20
0300-20
0201-20
0202-20
0302-20
When using screwdriver bits, insert the
bit far enough for the chuck jaws to
grip the bit shank. Tighten the chuck
jaws by hand to align the bit.
To close the chuck jaws, place the
chuck key in each of the three holes in
the chuck. Turn the chuck key clock-
wise (Fig. 3). Tighten securely.
To remove the bit, insert the chuck key
into one of the holes in the chuck. Turn
the chuck key counterclockwise.
WARNING!
To reduce the risk of injury, do not
grasp the bit while the chuck is
rotating or while the bit is falling
from the chuck.
Double Sleeve Keyless
Chuck (Fig. 4, 5, & 6)
To open the chuck jaws, hold the collar
and turn the sleeve counterclockwise
(Fig. 4).
Fig. 4
Loosen
Tighten