Machine Installation; Uncrating Machine; Installing Batteries - Tennant 2510 Manual De Operador

MACHINE INSTALLATION

UNCRATING MACHINE

Carefully check carton for signs of damage. Report
damages at once to carrier.
Check Machine Contents to ensure package is
complete. Contact distributor for missing items.
Machine Contents:
2 -- Battery Cables #611116000
6 -- Black Battery Boots #611221
1 -- Battery Tray #604298
1 -- Dust Bag, Cloth (Installed) #900210.
1 -- Dust Bag, Paper #611781 -- Pack of 10
1 -- 20 inch Hair Blend Burnishing Pad (installed)
#611788 -- Carton of 5.
3 -- 12V 215AH Batteries #600394 (included with
machine PAC #9003532 and 9003536 only).
To uncrate your machine, remove straps and carefully
lift or use a ramp to remove machine from pallet.
Do not roll machine off pallet, damage may result.
ATTENTION: To prevent machine damage, install
batteries after removing machine from pallet.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
ATTENTION: You must remove wire- -tie before
operating machine.
Tennant 2510/2550 (08- -08)
Home Find... Go To..

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Recommended Battery Specifications:
Three 12 volt, deep cycle, 215 amp hour batteries.
Part Number #600394. Maximum battery dimensions
are 178 mm (7 in)W x 394 mm (15.5 in)L x 362 mm
(14.25 in)H.
1. Park machine on a level surface and set parking
brake, if equipped (Figure 1).
2. Turn OFF all switches. Remove key, if equipped.
3. Unlatch battery hood and open battery
compartment. Remove loose battery cables
(Figure 2).
OPERATION
FIG. 1
FIG. 2
7