Machine Installation; Uncrating Machine; Machine Setup; Attaching Squeegee Assembly - Tennant 5100 Manual Del Operador

OPERATION

MACHINE INSTALLATION

UNCRATING MACHINE

Carefully check carton for signs of damage. Report
any damage at once to carrier.
To uncrate your machine, remove shipping straps and
carefully lift or make a ramp to remove machine from
pallet.
Raise scrub head to transport position before
maneuvering machine. Step down firmly on scrub
head lift pedal to raise (Figure 1).
NOTE: To prevent scrub head skirt damage, always
keep machine in transport position when pad driver is
not installed.
FIG. 1
ATTENTION: Do not roll machine off pallet,
damage may occur.
Squeegee assembly is packaged with machine.
Brushes, pad driver and pads must be purchased
separately. Consult an authorized distributor for
specific pads and brushes.
ATTENTION: The use of supplies other than those
recommended by manufacturer may cause
damage.
6
Home Find... Go To..

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Raise squeegee mount bracket by moving
squeegee lift knob to the left (Figure 2).
FIG. 2
2. Loosen two thumb knobs on squeegee assembly
and slide squeegee into slots on squeegee mount
bracket (Figure 3).
FIG. 3
3. Tighten thumb knobs securely.
4. Connect vacuum hose from machine to squeegee
assembly (Figure 4).
FIG. 4
Tennant 5100 (01- -00)