Sony VPL-SW535C Manual De Referencia Rápida página 56

Performing Calibration (Position
alignment)
Use the supplied USB cable to connect the
projector to the computer. Click the IPU
driver icon in the Dock to display the pop-up
menu, then select [Calibrate].
Calibrate
About IPU driver
Options
Hide
Quit
[Calibrate] appears in the pop-up menu
when your computer is connected to the
projector.
Calibration is the operation to align the pen
position on the projection surface with the
mouse position on the computer screen. Be
sure to perform calibration when using the
Interactive function for the first time.
Changing resolution or moving the projector
may offset the current calibration. In this
case, perform calibration again.
Calibration (Position alignment)
A flashing dot appears in the top left of the
screen. Touch the center of the dot with the
tip of the Interactive Pen Device until the dot
stops flashing.
The dots appears from the top left to bottom
right of the screen. Repeat the above for all
dot positions to complete calibration.
22
GB
Using the Interactive Function
Note
Make sure you touch the center of the dot,
otherwise positioning may be offset.
Operating with the Interactive Pen
Device
With the Interactive Pen Device, you can use
the functions of the toolbar on the screen.
See "Toolbar" for details.
Closing Interactive Presentation
Utility
One by one, right-click the icon of IPU
driver and Interactive Presentation Utility in
the Dock to display the pop-up menu, then
select [Quit].