Assembling And Disassembling The Sanding Disc And Wool Bonnet - Hitachi Koki SP18VA Instrucciones De Seguridad Y Manual De Instrucciones

ASSEMBLING AND DISASSEMBLING THE SANDING DISC AND
WOOL BONNET
WARNING:
For use as a Sander (Fig. 4)
(1) After placing the sanding disc on the rubber
pad, thread the washer nut onto the spindle.
(2) Press the lock pin to secure the spindle and
tighten the washer nut with a wrench.
(3) To remove the sanding disc, follow the
above-mentioned procedure in reverse
order.
For use as a Polisher (Fig. 5)
(1) Insert the washer nut through the rubber
pad and thread it onto the spindle.
(2) Press the lock pin to secure the spindle and
tighten the washer nut with a wrench.
(3) Wrap the rubber pad with the hood of the
wool bonnet and firmly secure it by tying a
string around it. Be sure the excess string
is firmly tucked inside the wool bonnet to
prevent it from flying out while polishing.
The unbalanced fitting of the wool bonnet
may cause vibration (Fig. 6).
(4) To remove the wool bonnet, follow the
above-mentioned procedure in reverse
order.
CAUTION:
Use a wrench to tighten the washer nut
sufficiently.
After releasing the lock pin, check to be
sure that it has returned to its normal
position.
Be sure to switch power OFF and disconnect the plug from the
receptacle to avoid serious trouble.
Tuck the excess
string into
Washer
Nut
Rubber
Pad
Washer
Nut
Rubber
Pad
Fig. 5
Fig. 6
English
Sanding
Disc
Spindle
Lock Pin
Fig. 4
Wool
Bonnet
Spindle
Lock Pin
Hood
13