Yamaha RX-V663 Manual De Instrucciones página 72

Customizing this unit (MANUAL SETUP)
Input menu 4 INPUT MENU
Note
Some parameters described below may not be available for all input sources and some parameters are only available for specific input
sources.
Parameter
I/O ASSIGNMENT
INPUT RENAME
VOL. TRIM
DECODER MODE
STANDBY CHARGE
START PAIRING
BGV
INPUT CH
FRONT
Option menu 5 OPTION MENU
Menu
A)DISPLAY SET
DIMMER
OSD SHIFT
OSD-SOURCE
OSD-AMP
FL SCROLL
B)VIDEO SET VIDEO CONV.
70
En
Assigns the input/output jacks according to the component to be used if the initial settings of
this unit do not correspond to your needs.
Changes the name of the input source that appears in the OSD and in the front panel display.
Adjusts the level of the signal input at each jack.
Switches the decoder activation mode. You can designate the reassigned digital input jacks for
DTS signals.
Selects whether this unit charges the battery of the stationed iPod or not when this unit is in the
standby mode (see page 29).
Pair the connected Yamaha Bluetooth adapter (such as YBA-10, sold separately) with a
Bluetooth component (see page 59).
Selects the video source played back in the background of the sources input at the MULTI CH
INPUT jacks.
Selects the number of channels input from an external decoder.
Selects the analog jacks at which the front channel signals from an external decoder are input
when you set "INPUT CH" to "8CH".
Parameter
Adjusts the brightness of the front panel display.
Adjusts the vertical position of the OSD.
Sets the amount of time to display the iPod menu in the video monitor
after you perform a certain operation.
Sets the amount of time to display the status information screen after
you perform a certain operation.
Selects the mode to display the information of the iPod menu in the
front panel display.
Selects whether to convert the video signals input at the VIDEO,
S VIDEO, and COMPONENT VIDEO jacks.
Functions
Functions
Page
81
82
82
82
82
83
83
83
83
Page
84
84
84
84
84
85