Advanced Setup; Using The Advanced Setup - Yamaha RX-V663 Manual De Instrucciones

This unit has additional menus that are displayed in the front panel display. The advanced setup menu offers additional
operations to adjust and customize the way this unit operates. Change the initial settings (indicated in bold under each
parameter) to reflect the needs of your listening environment.
Notes
• The settings you make are reflected next time you press K MAIN ZONE ON/OFF to turn on this unit (see page 29).
• Only K MAIN ZONE ON/OFF, L SYSTEM OFF, M TONE CONTROL and the N PROGRAM selector are effective while you
are using the advanced setup menu.
• No other operations can be made while you are using the advanced setup menu.
• The advanced setup menu is only available in the front panel display.

Using the advanced setup

Press L SYSTEM OFF on the front panel to
1
set this unit to the standby mode.
Press and hold M TONE CONTROL and
2
then press K MAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
TONE CONTROL
down
Rotate the N PROGRAM selector to select
3
the parameter you want to adjust.
The name of the selected parameter appears in the
front panel display.
SP IMP.-8 MIN
Currently selected
parameter
Press M TONE CONTROL repeatedly to
4
change the selected parameter setting.
Press L SYSTEM OFF to save the new
5
setting and set this unit to the standby mode.
y
The settings you made are reflected next time you turn on
this unit.

Advanced setup

■ Speaker impedance
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8ΩMIN, 6ΩMIN
• Select "8ΩMIN" to set the speaker impedance to 8 Ω.
• Select "6ΩMIN" to set the speaker impedance to 6 Ω.
MAIN ZONE
ON/OFF
Currently selected
parameter setting
*
SP IMP. Speaker
Front
8ΩMIN
Center
Surround
Surround back
Front
6ΩMIN
Center
Surround
Surround back
The Canada model cannot use two separate speaker systems
(A and B) simultaneously when "SP IMP." is set to "8ΩMIN".
ADVANCED SETUP
SP IMP.
Impedance level
If you use one set (A or B),
the impedance of each
speaker must be 8 Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16 Ω or
*
higher.
The impedance of each
speaker must be 8 Ω or
higher.
If you use one set (A or B),
the impedance of each
speaker must be 4 Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8 Ω or
higher.
The impedance of each
speaker must be 6 Ω or
higher.
95
En