Know Your Table Saw; Accessory Storage - RIDGID R4514 Manual Del Operador

FEATURES
RIP FENCE
STORAGE AREA
DUST CHUTE

KNOW YOUR TABLE SAW

See Figures 2 - 3.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ACCESSORY STORAGE - Convenient storage areas for the
push stick, riving knife, wrenches, blade guard, miter gauge,
anti-kickback pawls, and rip fence are located underneath
the saw table.
ANTI-KICKBACK PAWLS - Kickback is a hazard in which
the workpiece is thrown back toward the operator. The teeth
on the removable anti-kickback pawls point away from the
workpiece. If the workpiece should be pulled back toward
the operator, the teeth dig into the wood to help prevent or
reduce the possibility of kickback.
BEVEL ADJUSTING HANDWHEEL - Located on the front
of the saw, this handwheel is used to make the adjustment
for bevel angles.
BEVEL LOCKING LEVER - This lever under the worktable
surface on the front of the saw, locks the angle setting of
the blade.
BEVEL SCALE - The easy-to-read scale on the front of the
saw shows the exact blade angle.
RIVING KNIFE, BLADE
WRENCH, ANTI-
KICKBACK PAWLS
AND BLADE GUARD
STORAGE AREA
BLADE - For maximum performance, it is recommended
that you use the 10 in. carbide tipped combination blade
provided with your saw. The blade is raised and lowered with
the height adjusting knob . Bevel angles are locked with the
bevel locking lever. Additional blade styles of the same high
quality are available for specific operations such as ripping.
Your local dealer can provide you with complete information.
Blade kerf width must be within the limits stamped on the
riving knife.
WARNING:
Do not use blades rated less than the speed of
this tool. Failure to heed this warning could result
in personal injury.
BLADE GUARD - Always keep the guard down over the
blade for through-sawing cuts.
BLADE HEIGHT LOCK KNOB - This knob, in the center of
the bevel adjusting handwheel, locks the height of the blade.
ELECTRIC BRAKE - An electric brake has been provided
to stop blade rotation after the saw is turned off.
HEIGHT ADJUSTING KNOB - Located on the front of
the saw, this knob is used to lower and raise the blade for
adjustments or blade replacement.
11 − English
PUSH STICK AND
MITER GAUGE
STORAGE AREA
Fig. 3