Know Your Table Saw - RIDGID R4520 Manual Del Operador

FEATURES
ANTI-KICKBACK
PAWLS, RIVING KNIFE,
AND BLADE GUARD
STORAGE AREA
RIP FENCE
STORAGE
BRACKETS

KNOW YOUR TABLE SAW

See Figures 2 - 3.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ACCESSORY STORAGE - Convenient storage areas for the
push stick, riving knife, wrenches, blade guard, miter gauge,
anti-kickback pawls, and rip fence are located underneath
the saw table.
ANTI-KICKBACK PAWLS - Kickback is a hazard in which
the workpiece is thrown back toward the operator. The teeth
on the removable anti-kickback pawls point away from the
workpiece. If the workpiece should be pulled back toward
the operator, the teeth dig into the wood to help prevent or
reduce the possibility of kickback.
BEVEL ADJUSTING HANDWHEEL/BEVEL LOCK KNOB -
The bevel adjusting handwheel, located on the side of the
cabinet, is used to adjust the bevel angle of the blade.The
bevel lock knob locks the angle setting of the blade.
BEVEL SCALE - The easy-to-read scale on the front of the
cabinet shows the exact blade angle.
PUSH
STICK
BLADE - For maximum performance, it is recommended
that you use the 10 in. carbide tipped combination blade
provided with your saw. The blade is raised and lowered with
the height adjusting handwheel. Bevel angles are locked with
the bevel lock knob. Additional blade styles of the same high
quality are available for specific operations such as ripping.
Your local dealer can provide you with complete information.
Blade kerf width must be within the limits stamped on the
riving knife.
BLADE GUARD - Always keep the removable blade guard
down over the saw blade for through-sawing cuts.
BRAKE - A brake has been provided to stop blade rotation
after the saw is turned off.
FOOT PEDALS - The foot pedals are used to raise and
lower the saw table.
HEIGHT ADJUSTING HANDWHEEL/ HEIGHT LOCK
KNOB - The height adusting handwheel, located on the
front of the cabinet, is used to lower and raise the blade for
height adjustments or blade replacement. The height lock
knob locks the height setting of the blade.
11 - English
WARNING:
Do not use blades rated less than the speed of
this tool. Failure to heed this warning could result
in personal injury.
BLADE AND
WRENCH
STORAGE AREA
MITER GAUGE
STORAGE AREA
Fig. 3