Assembling The Leg Stand - RIDGID R4514 Manual Del Operador

Sierra de mesa de 254 mm (10 pulg.)
Ocultar thumbs Ver también para R4514:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY

ASSEMBLING THE LEG STAND

See Figures 7 - 13.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
Many of the leg stand parts are movable. All hardware must
be tightened securely but not so tight that the leg stand
won't open and close. For easier assembly, match number to
number and fingertighten all fasteners. Only tighten fasteners
securely when you are sure the release lever locks over the
center brace.
 Align handle with holes in the end of the upper tube and
insert. Secure in place using a bolt (M6 x 40 mm) and hex
nut (M6). Repeat for other side.
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
 Insert a carriage bolt (M8 x 80 mm) through the top hole
of the inner leg assembly then slide a large spacer on the
bolt. Repeat for the other side.
 Slide the center brace onto the bolt and secure in place
using a lock nut (M8). Repeat for the other side.
NUMBERS
CENTER
BRACE
Fig. 7
16 − English
BOLT
HEX
NUT
LEFT
HANDLE
LARGE
SPACER
LOCK
NUT
STOP PIN
UPPER
TUBE
RIGHT
HANDLE
Fig. 8
CARRIAGE
BOLT
INNER LEG
ASSEMBLY
Fig. 9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido