Before Use; Installation - cecotec CONGA 3690 Manual De Instrucciones

3. BEFORE USE

• Take the product out of the box and remove all packaging material.
• Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Technical Support Service immediately.

4. INSTALLATION

Robot and charging base installation
1. Connect the charging base to a power supply and
store the remaining cable. It is important to store the
remaining cable at the bottom of the charging base to
avoid it from being dragged and disconnected.
2. Place the charging base against the wall, leaving the
safety distance indicated in the below picture.
Note: ensure a space of at least 1 m on both the left and right
side of the charging base, and a space of at least 2 m in front of it.
WARNING: do not expose the charging base to direct sun light.
3. Long press the
robot on the charging base.
Note:
• Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
• The robot will automatically turn on when placed on the charging base.
• The robot cannot be turned off during charging.
button for 3 seconds; when the light indicator turns on, place the
• Steady blue light: ON/operating
• Orange light oscillates: charging
• Red light blinks: error
ENGLISH
1m
1m
2m
27