Programming The Set Points; Rainfall Set Point; Temperature Set Point (Rain/Freeze Sensor Only); Programming Irrigation Modes - Rain Bird WR2 Serie Manual Del Usuario

5. The Sensor is successfully paired to the Controller
the Sensor indicates signal strength for 20 minutes
features are an indication that your WR2 Wireless Sensor is
operational.
5

Programming the Set Points

the contractor may elect to use the "Standard Setting":
irrigation" mode. The "Standard Setting" is programmed at
the factory and is active after successful pairing.

Rainfall Set Point

2. When the Rainfall Indicator
6
WR2 Wireless Sensor
keypad to navigate to the
Rainfall Indicator icon.
+
/
programming details. Each
set point. Select from six (6) set
points ranging from 1/8" (3mm)
to 1/2" (13mm).
accept programming details
and to navigate to next icon.
Temperature Set Point
(Rain/Freeze Sensor only)
6
Programming Irrigation
Modes
–
keypad to navigate to the
Temperature Indicator icon.
2. When the Temperature
+ –
/
to set programming details.
Select one of three temperature
or 41°F (5°C).
accept programming details
and to navigate to next icon.
keypad to navigate to the
Irrigation Mode icon.
2. When the Irrigation Mode icon
+ –
/
to set programming details.
Manually set one of three
irrigation modes. See Irrigation
Modes.
accept programming details
and to navigate to next icon.