Watching TV
Insert the CableCARD™ when watching cable TV. (p. 11)
- -
Note
•
Reselect "Cable" or
"Antenna" in "ANT
In" of "Auto program"
to switch the signal
reception between
cable TV and antenna.
(p. 14)
•
The channel number
and volume level
remain the same even
after the TV is turned
off.
Switch to TV mode
1
Turn power on
2
•
POWER button on
unit should be On.
Close TV Guide
3
Select a channel number
4
up
or
down
To directly input the digital channel number
•
-
When tuning a digital channel, press the button to enter
the minor number in a compound channel number.
example: CH15-1:
To not display TV Guide when turning power On
Select "SETUP"
Select "Change default options" and press "OK" button
Select "General defaults" and press "OK" button
5
Select "auto guide" and set "off"
6
Select "done" and press "OK" button
TV Guide open up
-
select
17