Pc Input Terminals Connection - Panasonic TH-42PX600U Manual De Instrucciones

Technical Information
•
Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
•
Some PC models cannot be connected to the set.
•
There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.
•
The maximum resolution
Aspect
If the display resolution exceeds these maximums, it may not be possible to show fine detail with
sufficient clarity.
•
Signal Names for D-sub 15P Connector
11 12 13
6 7 8 9
1 2 3
Pin Layout for PC Input
Terminal
With the IR Blaster connection, scheduled recording can be done easily by using the TV Guide feature in this set.
Connect the IR Blaster if you wish to send remote control signals from the plasma TV to control the recording of a
connected video recorder (VCR).
Position the IR Blaster emitter facing the signal sensor of the video recorder and you will be able to easily record
programs from digital broadcasts. (p. 46)
The TV acts as a proxy for some remote control operations of the VCR.
TV
Setting the recording time,
channel and recording mode, etc.
56

PC Input Terminals Connection

Model No.
4:3
16:9
Pin No. Signal Name
14 15
10
4 5
NC (not connected)
5
GND (Ground)
The TV converts scheduling data
displayed on the TV to a remote
control signal and sends it
VCR
TH-42PX600U
768 × 768
1,024 × 768
Pin No.
6
R
7
G
8
B
9
NC (not connected)
10
IR Blaster connection
No need to set recording
time or channel on the video
recorder
TH-50PX600U
1,024 × 768
1,366 × 768
Signal Name Pin No.
11
GND (Ground)
12
GND (Ground)
13
GND (Ground)
14
15
GND (Ground)
G-LINK jack
IR Blaster (Supplied)
G - L
I N K
C a
b l e
C A
R D
TM
Video recorder (VCR)
TH-58PX600U
1,024 × 768
1,366 × 768
Signal Name
NC (not connected)
NC
HD/SYNC
VD
NC
Infrared emitter