Assembly; Operation - Husqvarna SR600-2 Manual De Usuario

SAVE THESE
INSTRUCTIONS
To assemble the attachment
1. Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin
hole comes over the corresponding hole in the drive
shaft.
2. Fasten the roller shaft with locking pin (B).
3. Thread one of the brush drums (C) onto the fitted
axle. The end with the extended rubber lamellas is
assembled closest to the gear housing. Press in the
brush drum.
4. Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
1. Run the basic product warm and then shut down the
product.
224

Assembly

E
B
F
D
A
C

Operation

E
5. Repeat these steps to assemble the axle and roller
on the opposite side. The drums are identical but
must be assembled with the extended rubber
lamellas towards the gear housing.
6. Mount the splash guard with the snap-on fasteners
(E).
Note: For assembling accessories on basic product,
refer to manual for basic product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburetor, make sure that the
brush drums are held against the ground and that no
one else is in the vicinity.
4. Make sure the brush drums are idling.
746 - 002 - 13.12.2019