Speaker Balance Adjustment - Yamaha DSP-A595 Manual De Instrucciones

SPEAKER BALANCE ADJUSTMENT

This procedure lets you adjust the sound output level balance between the main, center and rear speakers using the built-in test
tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from
each speaker. This is important for the best performance of the digital sound field processor, the Dolby Digital decoder and the
Dolby Pro Logic Surround decoder.
The adjustment of each speaker output level should be done at your listening position with the remote control transmitter.
After completing the adjustment of the output level for each speaker, use VOLUME (
ter at your listening position to check if the adjustments are satisfactory.
2
3 4 4,7
Set the SELECTOR DIAL to the AMP/TUN or DSP position
on the remote control transmitter.
1
Set VOLUME to the "∞" position.
Front panel
1
or
) on the remote control transmit-
2
2
Turn the power on.
Front panel
3
Select the main speakers to be used.
Front panel
* If you use two main speaker systems, press both A and B.
5,9
6
8
Remote control
or
21