Listening To The Am/Fm Radio - Onkyo TX-8260 Manual De Instrucciones

> Before Start > Part Names

Listening to the AM/FM Radio

1
You can receive AM/FM radio stations on
this unit with the built-in tuner. Perform the
following procedure when the unit is on.
∫ Tuning into a Radio Station
Tuning Automatically
1. Repeatedly press TUNER (a) on the
remote controller and select "AM" or
"FM".
2. Press TUNING MODE on the main unit
so that "TunMode: Auto" appears on the
display.
TunMode : Auto
3. When you press the cursor Up/Down
buttons (b) on the remote controller,
automatic tuning starts, and searching
stops when a station is found. When
tuned into a radio station, the "TUNED"
indicator on the display lights. When
tuned into a stereo FM radio station, the
22
> Install > Initial Setup
2
"FM ST" indicator lights.
When FM broadcasts reception is poor:
Perform the procedure for "Tuning
Manually" in the following section. Note
that if you tune manually, the reception for
FM broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
Tuning Manually
If you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Repeatedly press TUNER (a) on the
remote controller and select "AM" or
"FM".
2. Press TUNING MODE on the main unit
so that "TunMode: Manual" appears on
the display.
TunMode : Manual
> Playback
Supplementary information | Advanced Setup | Others
3
3. While pressing the cursor Up/Down
buttons (b) on the remote controller,
select the desired radio station.
0 The frequency changes by 1 step
each time you press Up/Down
buttons. The frequency changes
continuously if the button is held down
and stops when the button is
released.
a
b