Onkyo TX-8260 Manual De Instrucciones página 7

> Before Start > Part Names











> Install > Initial Setup









> Playback
Supplementary information | Advanced Setup | Others
Remote Controller
1. Í ON/STANDBY button
2. INPUT SELECTOR buttons: Switches the input to be played.
3. Play buttons: Used to control play of a Music Server or device connected via USB, or of
RI connected devices.
0 The , , and buttons can only be used when playing RI connected devices.
4. REPEAT button: Used for repeat play operations when playing Music Server or USB.
Each time you press the button, the mode switches from
(folder repeat).
5. SPEAKER A/B button: Select the terminals to output audio from between SPEAKERS A/B.
6. Cursors (Up / Down / Left / Right), ENTER button: Select the item with the cursors and
press ENTER to confirm.
7. SETUP button: You can show advanced setting items on the display to provide you with
an even better experience (P31).
8. CH (i/j) buttons: Used to select AM/FM radio stations.
9. Numbered buttons
10.DISPLAY button: Switches the information on the display. You can display information
such as the input source, volume, and input format when pressed repeatedly during play.
11. DIMMER button: You can adjust the brightness of the display in three steps. It cannot be
turned off completely.
12.REMOTE MODE MAIN/ZONE 2 buttons: Controls the multi-zone function (P27).
13.RANDOM button: Used for random play operations when playing Music Server or USB.
Random turns on or off each time you press the button
14.MENU button: Used to display the menu.
15.RETURN button: Returns the display to the previous state during setting.
16.AUDIO button: Use for setting "Bass", "Treble", etc. (P29).
17.VOLUME
18.MUTING button: Temporarily mutes audio. Press again to cancel muting.
19.CLR button: Deletes all characters you have entered when entering text. (P15)
20.SLEEP button: Set the sleep timer. Press the button repeatedly to select the time. When
the time set (30, 60, or 90 minutes) has elapsed, the unit switches to standby. If SLEEP
button is pressed after setting, the time remaining until sleep is displayed.
* When the remote controller isn't working:
Tips
The remote controller may have switched to the
mode for controlling ZONE 2. Press REMOTE
MODE MAIN to switch to the mode to control the
main room.
(1-track repeat) to
.
En 7