Yamaha HTR-5630RDS Manual De Instrucciones página 17

I Connections
Be sure to connect the left channel (L), right channel (R), "+" (red) and "–" (black) in accordance with the markers on
this unit, the speakers, and the speaker cables. If the connections are faulty, no sound will be heard from the speakers,
and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.
CAUTION
• Use speakers with the specified impedance shown on the rear panel of this unit.
• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/
or the speakers.
10 mm (3/8")
1
Connecting to the MAIN A SPEAKERS terminals
Red: positive (+)
Black: negative (–)
Banana plug
(With the exception of U.K., Europe, Korea, and
Singapore models)
Connecting to the MAIN B, CENTER and REAR SPEAKERS terminals
Red: positive (+)
Black: negative (–)
2
2
1
3
1
3
2
A speaker cord is actually a pair of insulated cables
running side by side. One cable is colored or shaped
differently, perhaps with a stripe, groove or ridge.
1
Remove approximately 10 mm (3/8") of
insulation from each of the speaker cables.
2
Twist the exposed wires of the cable
together to prevent short circuits.
1
Unscrew the knob.
2
Insert one bare wire into the hole in the side
of each terminal.
3
Tighten the knob to secure the wire.
y
(With the exception of U.K., Europe, Korea, and Singapore
models)
• You can also use banana plug connectors. First, tighten the
knob and then insert the banana plug connector into the end of
the corresponding terminal.
1
Press and open the tab.
2
Insert one bare wire into the hole of each
terminal.
3
Release the tab to secure the wire.
CONNECTIONS
15