Dry Cutting; Diamond Blade - Requirements; To Examine The Spindle Shaft And Flange Washers - Husqvarna K 535i Manual De Usuario

Dry cutting

• When dry cutting, lift the blade out from the cut each
30–60 seconds and let it rotate in the air for 10
seconds to let it cool.
• Use Vac equipment if possible.

Diamond blade - requirements

WARNING: Make sure the diamond
segment (T1) is wider than the blade (T2).
This is to prevent pinching in the cutting slot
and a kickback.
T1
T2
CAUTION: Do not use diamond blades with
positive rake angles.
CAUTION: Do not use diamond blades with
greater gap between segments than max 10
mm (A).
12
A
CAUTION: Do not use diamond blades with
greater blade thickness than recommended
maximum, refer to
22 .
CAUTION: Some cutting situations and
worn blades may cause increased wear on
the side of the segments. Replace the blade
before it is worn out.
To examine the spindle shaft and
flange washers
Examine the flange washers and the spindle shaft when
the blade is replaced.
CAUTION: Use only flange washers
supplied by Husqvarna with minimum
diameter 60 mm/2.4 in.
CAUTION: Do not use damaged, defective
or dirty flange washers.
CAUTION: Do not use different dimensions
of flange washers.
• Make sure that the threads on the spindle shaft are
not damaged.
• Make sure that the surfaces on the blade and the
flange washers are not damaged, of the correct
dimension, clean, and that they run correctly on the
spindle shaft.
Technical data on page
745 - 008 - 12.11.2018