To Examine The Arbor Bushing; To Attach The Cutting Blade; To Examine The Blade And The Blade Guard; Rope Eyelet - Husqvarna K 535i Manual De Usuario

Ocultar thumbs Ver también para K 535i:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To examine the arbor bushing

Use only Husqvarna arbor bushings.
Make sure that the arbor bushing has the correct
dimension for the cutting blade. The correct
dimension is printed on the cutting blade.

To attach the cutting blade

1. The cutting blade is put on the bushing (A) between
the inner flange washer (B) and the flange washer
(C). The flange washer is turned to attach to the
axle.
B
2. Lock the shaft.
3. Tighten the bolt. The tightening torque for the bolt
holding the cutting blade is 30 Nm (18,5 ft-Ibs).
745 - 008 - 12.11.2018
A
C
To examine the blade and the blade
guard
WARNING: A damaged cutting blade can
cause injury.
1. Make sure that the cutting blade is attached correctly
and does not show signs of damage.
2. Make sure that the blade guard has no cracks or is
damaged.
3. Replace the blade guard if it is damaged. See
attach the cutting blade on page 13

Rope eyelet

The product has a rope eyelet. The rope eyelet can be
used to lift and lowering the product. Attach an
applicable strop to the rope eyelet to use it for lift and
lowering.
The rope eyelet can be used to attach the product to a
solid object to prevent it from fall and damage persons
or equipment.
To
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido