Sony HT-RT5 Manual De Instrucciones página 42

 [Level]
You can adjust the sound level of the
speakers after setting [Auto Calibration].
You can set the parameters from –6.0 dB
to +6.0 dB. Be sure to set [Test Tone] to
[On] for easy adjustment.
[Front Left/Right] 0.0 dB: Set the front
speaker level.
[Center] 0.0 dB: Set the center speaker
level.
[Surround Left/Right] 0.0 dB: Set the
surround speaker level.
[Subwoofer] 0.0 dB: Set the subwoofer
level.
Adjust the sound level based on the
default subwoofer volume VOL 10
(page 59).
 [Relocation]
You can correct the speaker position
virtually to improve the surround effect.
[On]: You can hear sound from a virtually
relocated speaker position determined by
[Auto Calibration].
[Off]: You can hear sound from the actual
speaker position.
Note
• This setting is only reflected after
performing [Auto Calibration].
 [Test Tone]
The speakers will emit a test tone to
adjust [Level].
[Off]: The test tone is not emitted from
the speakers.
[On]: The test tone is emitted from each
speaker in sequence while adjusting
level. When you select one of the
[Speaker Settings] items, the test tone is
emitted from each speaker in sequence.
Adjust the sound level as follows.
1
Set [Test Tone] to [On].
Press / to select [Level], then
2
press .
Press / to select the speaker type
3
you want, then press
42
US
4
5
6
7
8
9
Notes
• The test tone signals are not output from
the HDMI OUT (ARC) jack.
• If no sound is output from the subwoofer,
please check whether the subwoofer
volume is not VOL 0.
.
Press / to select the left or right
speaker, then press / to adjust
the level.
Press .
Repeat Steps 3 to 5.
Press BACK.
The system returns to the previous
display.
Press / to select [Test Tone], then
press .
Press / to select [Off], then press
.