Lubrication; Jaws; Long-Term Storage; Worn Product - Husqvarna DCR300 Manual De Instrucciones

Ocultar thumbs Ver también para DCR300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lubrication

The greasing points are indicated with a red circle. Replace
damaged nipples.
DCR300
DCR100
12 –
English
MAINTENANCE

Jaws

!
Check the wear of the crushing surfaces on the jaws and add
filling material if necessary.
Before adding filling material, remove all remains of paint,
as these can cause developement of toxic gases.
Preheat the surface up to 150-200 °C.
After adding filling material, let cool slowly to room
temperature.
Recommended welding wire
ESAB OK 83.30 DIN 8555-E1 300
ESAB OK 83.50 DIN 8555-E6-55
SIEV-FRO B-500
SIEV-FRO B-600
Replaceable tips (DCR300)
The tips can be removed for welding work or replaced if worn
out.

Long-term storage

Ensure the machine is cleaned and that a complete service is
carried out before long-term storage.

Worn product

This machine has the prerequisites to last for many years.
This minimizes the machine's environmental impact. Perform
service and maintenance according to the instructions in this
manual. This way the engine will last longer and the
hazardous emissions are minimized.
When the machine is worn out it should be disposed of for
recycling or scrapping.
Follow local regulations for disposal and recycling.
CAUTION! The dismounting and mounting of
the main pivots of the jaws has to be carried
out by an authorized service workshop.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dcr100

Tabla de contenido