Pilot Method; Cutting Depth; Large Work - Husqvarna K6500 II Ring Manual De Instrucciones

Before starting the cut the pipe must be secure so it does
not move or roll during cutting.
If the pipe is allowed to sag and close the cut, the blade
will be pinched in the kick back zone and a severe kick
back might develop.
If the pipe is properly supported the end of the pipe will
move downward, the cut will open and no pinching will
occur.
Proper sequence cutting a pipe
1 First cut section I.
2 Move to side II and cut from section I to bottom of the
pipe.
3 Move to side III and cut the remaining part of the pipe
ending at the bottom.
I
III
How to aviod kickback
Avoiding kickback is simple.
The work piece must always be supported so that the cut
stays open when cutting through. When the cut opens
there is no kickback. If the cut closes and pinches the
blade there is always a risk of kickback.
Take care when inserting the blade in an existing cut.
Be alert to movement of the work piece or anything else
that can occur, which could cause the cut to close and
pinch the blade.
OPERATING
II

Pilot method

WARNING! Never use a power cutter with
!
a standard cutting blade for pilot cutting.
The cutting blade produces a pilot slot
that is too thin and continued cutting
with the ring cutter results infallibly in
dangerous kickback and jamming in the
slot.
This method is recommended when attempting to cut
absolutely straight and square.
For best cutting economy, pre-cut with a power cutter
equipped with Husqvarna's special pre-cutting blade
intended for further cutting with ring cutter.

Cutting depth

K6500 Ring can cut up to a depth of 270 mm (10,6
inches). Making a guide cut of 50-70 mm (2-3 inches) first,
gives you better control of the machine. This means the
water disc can penetrate into the workpiece and help
control the machine. Attempting to saw the entire depth in
one run takes longer. Working with several runs, 3 to 4
when the cut is 270 mm (10,6 inches) in depth, is much
quicker.
1 2 3 4
270 mm
10,6"

Large work

Cuts exceeding 1 m - secure a batten along the line to be
cut. The batten acts as a guide. Use this guide to make a
marking cut along the entire length of the cut, 50-70 mm
(2-3 inches) in depth. Remove the guides once the
marking cut has been made.
–
English 19