Husqvarna FS7000 DL Manual De Instrucciones página 27

• Set Speed control lever to the STOP position. The engine
will not start unless the Speed control lever is in the
distinct STOP position.
NOTICE! Check to be certain, the transmission bypass
valve is closed in the down position.
• When preheat symbol is displayed, wait for the engine
glow plugs to warm the engine. When the preheat symbol
disappears turn the Engine start switch to position engine
start to start the engine.
2
1
• Let the engine warm up for several minutes with Engine
throttle at idle speed (minimum).
• Do not warm up the machine outside the cutting area, with
the blade installed and rotating. To fit the blade, see the
instructions under the heading Fitting the blade.
WARNING! When the engine is running the
!
exhaust contains chemicals such as
unburned hydrocarbons and carbon
monoxide. The content of the exhaust fumes
is known to cause respiratory problems,
cancer birth defects or other reproductive
harm.
Carbon monoxide is colorless and tasteless
and is always present in exhaust fumes. The
onset of carbon monoxide poisoning is
distinguished by a slight dizziness which
may or may not be recognized by the victim.
A person may collapse and lapse into
unconsciousness with no warning if the
concentration of carbon monoxide is
sufficiently high. Since carbon monoxide is
colorless and odorless, its presence can not
be detected. Any time exhaust odors are
noticed, carbon monoxide is present. Never
use a combustion engine powered product
indoors or in confined areas without
ensuring proper ventilation.
CAUTION! Pay special attention on
!
clutchless machines, blade starts rotating at
start. For safety reason, do not move the
saw sideways or out of the working area with
blade installed and rotating.
STARTING AND STOPPING
NOTICE! If all start conditions are not fulfilled this will be
shown on the display. Perform the action and try to start the
engine again.
Start the cutting
WARNING! Never use a blade with a lower
!
speed rating than that of the machine. Make
sure the blade is properly installed.
NOTICE! See chart for the appropriate blade shaft and
engine speeds for specific blade sizes in the display.
• Test for adequate water supply. Low water flow will cause
damage to diamond blades. Engage the Water safety
switch on the control panel and open the Water valve.
2
1 3
4
12
10 14
60
WORKING HOUR
16
8 40
V V
CURRENT: STOP:
0 0
cm cm
• Engage the Blade clutch (if equipped) to engage the blade
drive. Only at 1200rpm or less.
2
1
3
4
12 80
10 14 60 100
WORKING HOUR
8 16 40 120
V V c c
CURRENT: STOP:
0 4
cm cm
1200 rpm
• Set the Engine throttle knob to maximum rpm.
2
1 3
4
12 80
10 14 60 100
WORKING HOUR
8 16 40 120
V V c c
CURRENT: STOP:
0 4
cm cm
<1200 RPM
80
100
120
c c
<1200 RPM
<1200 RPM
– 27
English