Husqvarna FS7000 DL Manual De Instrucciones página 44

E-track motor Circuit short to
C1F0112
A battery
E-track motor Circuit short to
C1F0111
A ground
E-track motor Circuit short to
C1F0212
B battery
E-track motor Circuit short to
C1F0211
B ground
Output current
C1F0521 E-track motor
overload
C1F0513 E-track motor Circuit open
No CAN
U100187 Engine ECU
communication
44 –
English
TROUBLESHOOTING
Disconnect E-track and reset fault code. Press left and
right E-track button in an attempt to control E-track. If fault
code doesn't appear again check damage to E-track
actuator, harness and connector. (Fault codes C1E0511
and C1E0512 may appear instead since E-track is not
Cutting can
connected.)
continue but E-track
If fault code still exists check damage to cowling harness
can not be used for
and connector. If found, repair and reset fault codes.
drift compensation
until fault is
resolved.
If problem still exists, contact your service agent for further
information.
Cutting can
continue but E-track Check if E-track is stuck or jammed, and if so, resolve the
can not be used for problem and reset fault codes. Try E-track again after 1
drift compensation minute. If fault code still exists check contact your service
until fault is agent for further information.
resolved.
Check connection between E-track harness to Cowling
Cutting can
harness. Check connection between E-track actuator and
continue but E-track
E-track harness. Check damage to E-track and harness. If
can not be used for
found repair and reset fault codes.
drift compensation
until fault is
If problem still exists, contact your service agent for further
resolved.
information.
Check damage to connectors X1, X4, X14 and harness. If
Cutting can not
found, repair and restart system, reset fault code.
continue. No
information
If problem still exists, contact your service agent for further
available from ECU.
information.