en Basic operation
Push the attachment fully onto the
3.
drive.
Rotate the attachment anticlock-
4.
wise as far as possible.
→ Fig.
25
Close the locking lever.
5.
→ Fig.
26
Tighten the threaded ring clock-
6.
wise.
Attach the filling tray.
7.
→ Fig.
27
Place a suitable container under
8.
the attachment.
→ Fig.
28
Basic operation
Basic operation
You can find out everything you need
to know about operating your ac-
cessory here.
Recommended speeds
Observe the recommended speeds
for optimum results.
Note: Your model is equipped with a
4- or 7-level rotary switch depending
on the features of the appliance. The
recommended speeds for the 4-level
rotary switch are always shown in
brackets in these instructions for use.
Setting
Use
7 (4)
Meat mincer
7 (4)
Juicer attachment
4-5 (2-3)
Viennese whirl attachment
3-4 (2-3)
Shredding attachment
1
Special accessory
20
Processing food
WARNING
Risk of injury!
¡ Rotating drives, tools or accessory
parts may cause injury.
Do not reach into the filling
▶
shaft.
Only use the pusher to push
▶
down ingredients.
¡ Improper use may cause injuries.
Only use the accessories once
▶
fully assembled.
The accessories should only be
▶
used in the intended operating
position.
Prepare your food.
1.
Cut large items of food into pieces
so they fit into the filling shaft.
Insert the mains plug.
2.
Set the rotary switch to the recom-
3.
mended speed.
→ Fig.
29
Insert the food into the filling shaft
4.
and press down with the pusher,
applying light pressure.
→ Fig.
30
Set the rotary switch to
5.
→ Fig.
31
Wait until the appliance stops.
Pull out the mains plug.
6.
Processing food with the juicer
1
attachment
Note: When working with the juicer
attachment, note the following special
features.
Place two containers under the rel-
1.
evant openings.
Before starting processing, turn the
2.
setting screw anticlockwise and
open.
→ Fig.
32
.