Testing Operation; Service; Before Calling Service - Bosch HEI80 Instrucciones De Instalación

3. Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. The drawer should
insert easily. If it binds, do not attempt to force it.
Remove the drawer, align the slides on the housing to
the front edge of the housing and try again. Slide the
drawer into both housing slides at the same time, and
keep the drawer level while doing so.
4. The drawer has a "push-to-open" operation. Pressing
the front of the drawer inward causes the drawer to self
open.
5. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rail release levers
are properly positioned.

Testing Operation

1. Turn on power at the breaker.
2. Test the oven mode.
Select the BAKE mode. See the Use and Care Manual
for detailed operation instructions.
3. Verify that the oven light comes on and the oven begins
to preheat.
4. Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
5. If installing a double oven, test the second oven as
well.
6. If any of the tests do not result as explained above,
contact Bosch service for assistance. Otherwise, the
installation is complete at this time.

Service

Before Calling Service

See Use and Care Manual for troubleshooting information.
Refer to the Warranty in the Use and Care Manual.
To reach a service representative, see the contact
information at the front of the manual. Please be prepared
with the information printed on your product data plate
when calling.
Data Plate
The data plate shows the model and serial number. Refer
to the data plate on the appliance when requesting service.
The data plate is located on the inside of the warming
drawer frame.
English 14