Adjusting Handgrips; Backrest Cushions - Vermeiren D400 Manual De Instrucciones

2.14 Adjusting handgrips

L L L L
WARNING:
Risk of injury – Make sure that all screws are properly tightened.
L L L L
WARNING:
Risk of injury, Danger of tipping over – Make sure that the handgrips
on both sides are set to the same height.
L L L L
WARNING:
Risk of injury – Keep a safe distance from 50 mm on the bottom side
of the handgrip (in the backrest tubes).

2.15 Backrest cushions

L L L L
WARNING: Risk of injury – Check that all straps are secured with Velcro.
1. Remove the back rest cushion
the frontside to the front, back rest cushion
the back rest cushion
suspension system with straps
2. Loosen the velcro closures
3. Pull the respective strap
can be varied and the desired support of the back can be set.
4. Replace the back rest cushion
The handgrip
in the backrest tubes
1. Loosen the star knob
2. Move the handgrip in the desired height (Range
110 mm: stepless).
3. Retighten the star knob
The back rest cushions
removed or mounted with the velcro
strips
The back can be adjusted in its
flexibility, so the back of the user is
supported differently.
with the velcro
comes from the velcro straps
on the back side backwards. Now you can see the
that can be adjusted independently.
of the respective straps
to the desired position, the tension of the individual belts
.
Page 13
is height adjustable by moving these
.
.
again.
on the backrest velcro straps
.
. Pull the back rest cushion
.
D400
2013-06
can be
on
. Pull