To Charge The Battery; To Do An Emergency Start Of The Engine; To Connect The Jumper Cables - Husqvarna R 213C Manual De Usuario

3. Carefully push in the lock mechanism and tilt the
lamp to remove it from the brackets.
4. Put the new lamp in the lower slot on the lamp
housing. Use the type of lamp as given in
data on page 29 .
5. Press the lamp into the lock mechanism.
6. Put the lower end of the lamp cover into the slots on
the servo housing.
20
7. Connect the cables to the new lamp.
8. Attach the cover and tighten the screws.

To charge the battery

Technical
• Charge the battery if it is too weak to start the
engine.
• Use a standard battery charger.
• Always disconnect the charger before starting the
engine.
To do an emergency start of the
engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.

To connect the jumper cables

1. Remove the engine cover.
2. Remove the cover for the battery case.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
WARNING: Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
854 - 003 - 14.11.2018