To Adjust The Seat; To Engage And Disengage The Drive System; To Adjust Height Of The Steering Wheel; To Lift And Lower The Cutting Deck - Husqvarna R 213C Manual De Usuario

WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result
in engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.

To adjust the seat

The seat can be tilted forward. It can also be adjusted
lengthways. Loosen the handles below the seat to adjust
it forward or rearward.
To adjust height of the steering
wheel
WARNING: Do not adjust the height of the
steering wheel during operation of the
product.
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel. The correct
height is when your arm is in a 90 degrees angle
when you hold the steering wheel.
12
3. Turn the knob clockwise to tighten.
CAUTION: Make sure that the long end of
the knob points up.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever is found behind the left rear
wheel.

To lift and lower the cutting deck

To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
854 - 003 - 14.11.2018