Transportation, Storage And Disposal; To Safely Attach The Product On A Trailer For Transport - Husqvarna R 213C Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The engine apparently has no
power
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
Transportation
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
Use an approved trailer for transportation of the
product.
Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
854 - 003 - 14.11.2018
Cause
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission cold air intake or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 25 .
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 9 .
The blades are loose. See
One or more of the blades are unbalanced. See
24 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
16 .
The tire pressure is different on the right and left sides. See
page 21 .
The product is operated at a too high speed. See
page 14 .
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

To clean and change the air filter on page 18 .
Battery safety on page 9 .
To examine the blades on page 24 .
To examine the blades on page 24 .
To get a good cutting result on page 14 .
To get a good cutting result on page 14 .
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
To do a check
To examine the blades on page
To clean the product on page
Tire pressure on
To get a good cutting result on
Bat-
27

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R 216

Tabla de contenido