To Charge The Battery - Husqvarna P 520DX Manual De Usuario

b) Remove the cover in the cabin roof to replace
fuses 10–14.
c) Open the engine cover to replace fuses 15–19 .
To open the engine cover on page 30 .
Refer to
The fuses are in the fuse box in front of the
battery.
38
d) Remove the front cover of the steering column to
replace fuses 20–21. Refer to
install the front cover of the steering column on
page 29 .
e) For P 525DX Cabin, to get access to the front
cover remove the 4 screws on the air circulation
unit. Remove the air circulation unit.
2. Pull the fuse from the holder.
3. Replace the broken fuse with a new fuse of the
same type. Refer to
4. Attach the covers.
Note:
If the main fuse breaks again a short period
after you replace it, there is a short circuit. Repair the
short circuit before you operate the product again. Let
an approved service agent help you.

To charge the battery

• Charge the battery if it is too weak to start the
engine.
• Use a standard battery charger.
CAUTION:
charger or start booster. That will cause
damage to the electrical system of the
product.
• Always disconnect the charger before starting the
engine.
To remove and
Fuse overview on page 37 .
Do not use a boost
1593 - 002 - 22.12.2020