Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
− The loops of the stepper are only designed for upward
tensile load. Do not subject the loops to horizontal stress.
Checking the stepper and pack contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp
knife or other pointed object, you may quickly damage the stepper.
− Be very careful when opening.
1. Take the stepper out of the packaging.
2. Check to make sure that the delivery is complete (see fig. A).
3. Check whether the stepper or the individual parts exhibit damage. If this
is the case, do not use the stepper. Contact the manufacturer at the service
address specified on the warranty card.
Assembly
For the most part, the stepper is preassembled. You will need the enclosed Philips-
head screwdriver
Make sure there is enough unobstructed room. There should be at
least 2 feet (0.6 m) of unobstructed space around the workout area
(see fig. B).
1. Insert the two plastic feet
surface of the plastic feet must be pointing down at the end.
2. Screw each Philips-head screw
the frame tube.
3. Screw the adjustment screw
(see fig. D).
Workout preparation
Attaching the carabiner clip
You can work out on the stepper with or without the resistance band
To work out with the resistance band, proceed as follows:
− Screw the carabiner clip
− Attach the carabiner clip to the loop
biner clip back into a closed position (see fig. E).
8
to complete the last assembly steps.
6
in the frame tube
12
4
of the resistance band loose.
Checking the stepper and pack contents
7
into the predrilled hole on the bottom of
into the threading on the front housing
11
on the stepper and screw the cara-
(see fig. C). The bearing
5
13
2
.
11
Publicidad
Capítulos
Tabla de contenido
