Emptying The Dust Drum; Blowing Feature - RIDGID HD06001 Manual Del Usuario

OPERATION

Emptying the Dust Drum

WARNING: To reduce the risk
!
of injury from accidental starting,
unplug power cord before emptying
the drum.
1. Unplug Power Cord from power source.
2. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
3. Lift Powerhead Assembly from the
Dust Drum and set aside.
4. Empty Dust Drum into a proper waste
disposal container.
Drum
Latches (2)
Dust
Drum

Blowing Feature

Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Insert the larger end of the Tug-A-
Long Positive Locking Hose with Dual-
Flex into the Blowing Port of the Vac.
Engage the Hose Latch to the lip of the
Blowing Port. The Hose should snap
into place.
SP7072 HD06001 HD09001 ESF_HD06001 HD09001.indd 10
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk
!
of injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
!
blowing creates dust which might
be inhaled.
Blowing
Port
Hose
Tug-A-Long
Positive Locking
Hose with
Dual-Flex
10
Swivel
End of
Hose
Extension Wand
(Optional)
7/10/18 2:07 PM