Adjusting The Time Alignment; Using Subwoofer Output - Pioneer DEH-P9800BT Manual De Instrucciones

Audio Adjustments

Adjusting the time alignment

You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in Custom.
1 Use MULTI-CONTROL to select
TA Mode.
TA Mode appears in the display.
2 Press MULTI-CONTROL to select a unit
of distance.
Each press of MULTI-CONTROL selects the
unit of distance in the following order:
cm (centimeter)—inch (inch)
3 Use MULTI-CONTROL to select
Time Alignment.
Time Alignment appears in the display.
# Can't adjust TA. Set position FL/FR appears
when neither Front Left nor Front Right is se-
lected in the position selector mode (Position).
# When selecting OFF in TA Mode, you cannot
switch to Time Alignment.
4 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
Each time MULTI-CONTROL is pushed left or
right, the speaker is selected in the following
order:
1 Front speaker left
2 Front speaker right
3 Rear speaker right
4 Subwoofer right
5 Subwoofer left
6 Rear speaker left
1 1 1 1 2 2 2 2
6 6 6 5 5 5 4 4 4 3 3 3
Front speaker left—Front speaker right—Rear
speaker right—Rear speaker left—Subwoofer
left—Subwoofer right
# You cannot select subwoofer left and subwoo-
fer right when the subwoofer output is off.
5 Push MULTI-CONTROL up or down to
adjust the distance between the selected
speaker and the listening position.
Each time MULTI-CONTROL is pushed up or
down, the distance increases or decreases.
400.00cm to 0.00cm is displayed as the dis-
tance is increased or decreased, if you have
selected centimeters (cm).
160.0inch to 0.0inch is displayed as the dis-
tance is increased or decreased, if you have
selected inches (inch).
# You can adjust the distance for the other
speakers in the same way.
6 Press BAND to cancel the time align-
ment mode.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Use MULTI-CONTROL to select
Subwoofer1.
Subwoofer1 appears in the display.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
ON appears in the display. Subwoofer output
is now on.
# To turn subwoofer output off, press
MULTI-CONTROL again.
Section
14
83
En