Technical Specifications - Velleman VTSSC72 Manual Del Usuario

800 grit emery cloth or by using isopropyl alcohol and consequently applying a new
protective layer of solder.

Set the desired temperature after allowing the unit to idle at 250 °C for three
minutes. The station will be ready for use once the set temperature is reached.
Important
Remove and clean the tip daily. Remove excess solder from the barrel nut assembly
when installing a new tip, otherwise the tip may be fused to the heating element or to
the retaining assembly.
10. Maintenance

Soldering tips can be replaced simply by unscrewing the barrel nut assembly. Turn
off the station and allow it to cool down first. Damage to the soldering station may
occur if the system is left on and the removed tip has not been replaced.

After removing the tip, you should blow out any oxide dust that may have formed in
the tip receptacle. Be careful not to get dust in your eyes. Replace the tip and
tighten the screw. Pliers can be used to avoid contact with hot surfaces BUT
SHOULD BE USED WITH CAUTION because over-tightening may cause damage to
the element or fuse the tip to the element.

Tweezers tips can be replaced by releasing the screws on top. Make sure to align
the new tips properly and do not tighten the screws too hard to avoid damage.

The outer cover of the tweezers, iron and station may be cleaned with a damp cloth
using small amounts of liquid detergent. Never submerse the unit in liquid or allow
any liquid to enter the case of the station. Never use any solvent to clean the case.

If the tweezers, iron or station should become faulty or, for some reason does not
operate normally, the system should be returned to the service department of your
authorized dealer or service agent.
11.

Technical Specifications

power supply ............................................................................. 220-240 V~, 50 Hz
standard tip ............................................................... Ø 0.8 mm (Velleman BITC201)
max. heater power for soldering iron ................................................................ 80 W
temperature range ............................................................ 200-480 °C (392-896 °F)
soldering iron ............................................................. 200-480 °C (392-896 °F)
SMD tweezers ............................................................. 200-450 °C (392-842 °F)
low-voltage iron ........................................................................................... 32 V~
weight ...................................................................................................... 2.34 kg
dimensions ............................................................................... 90 x 110 x 130 mm
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulting from (incorrect) use of
this device. For more info concerning this product and the latest version of this
manual, please visit our website www.velleman.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or reduced to
any electronic medium or otherwise without the prior written consent of the copyright
holder.
V. 02 – 19/02/2019
VTSSC72
8 ©Velleman nv